Sanyo DWM-2500 - Manual (Page 15)

-E14-
Speaker
Front-L
0
Surround-L
Center Front-R
Surround-R
4
1
2
5
3, 6
2 3
SHIFT
TRIM
1, 4
Adjusting the Speaker Volume Balance
This unit is set to the standard level before shipping from the
factory. You may not need any adjustment.
But, depending on the size of the room and the placement of the
speakers, you may benefit from a fine adjustment.
In this case, follow the steps below. Please use the remote
control when the test tone sounds.
1. Press [FUNCTION] to select the “DVD/CD” function.
2. Press [ n ] to stop playback completely.
3. Press [TEST] on the remote control.
The “Speaker” screen appears on the TV screen.
Need help? Call
1-800-813-3435
“FNT-L 0” appears on the FL display.
The test tone will be heard from each speaker sequentially as
follows:
TV screen FL display Speaker
Front-L FNT-L 0 Front left speaker
Center CENT 0 Center speaker
Front-R FNT-R 0 Front right speaker
Surround-R SUR-R 0 Surround right speaker
Surround-L SUR-L 0 Surround left speaker
4. Press [VOLUME] + or - until the test tone becomes a
comfortable level.
5. If the test tone level is not the same from each speaker, press
[ p ] or [ o ] to adjust it while the speaker is activated.
The level appears on the TV screen and FL display.
Front-L: “0” ~ “-10” appears.
Center: “+10” ~ “-10” appears.
Front-R: “0” ~ “-10” appears.
Surround-R: “+10” ~ “-10” appears.
Surround-L: “+10” ~ “-10” appears.
If necessary, repeat this step again.
6. Press [TEST] to turn the test tone off.
Note:
If no adjustments are made, the original display returns after
the test tone cycles around 5 times.
Adjusting the Subwoofer Level
1. Press [TRIM] while holding [SHIFT] down.
“FNT-L 0” appears on the FL display.
Note: No test tone.
2. Press [ENTER] repeatedly to select “SUB.W”.
Note:
Each time the button is pressed, the FL display will show the
selected speaker and tone level.
3. Press [ p ] or [ o ] to adjust the level as desired.
SUB.W: “+10” ~ “-10” appears.
Note:
If another speaker is selected, the level can also be changed
as above.
4. Press [TRIM] while holding [SHIFT] down to turn it off.
Note:
If no adjustments are made, the original display returns after
approximately 10 seconds.
IMPORTANT INFORMATION:
Set the delay time for your center and surround speakers. See
“Setting Audio” on page E33.