SPX Cooling Technologies SD25 User Manual

Page 21

Advertising
background image

User’s Manual

June 2004

T-40409-A

Page 13

Use the following procedure to attach a Pistol Grip handle (part number 49-SD-10111) to an In-line
screwdriver. Refer to Viewing Screwdriver Functions on page 7 to view an illustration of the
In-line screwdriver that may help you with this procedure.

Attaching a Pistol Grip Handle

1. Remove the screwdriver-to-controller cable, if necessary.

2. Using a 5/32-in punch, hammer out the pin that attaches the throttle/trigger lever

to the In-line screwdriver.

3. Remove the throttle/trigger lever spring. It may fall out when you remove the

throttle/trigger lever so be prepared to catch it.

NOTE:

?

Put the throttle/trigger lever and spring into a safe place. If, in
the future, you remove the handle attachment, you will need
the throttle/trigger lever and spring to convert the screwdriver
back to the In-line model.

4. Carefully slide the In-line screwdriver into the handle attachment with the

forward/reverse and multi-purpose (auxiliary) buttons positioned on the top.

5. Position the handle on the bottom of the screwdriver, on the side of the

screwdriver opposite to the forward/reverse and multi-purpose (auxiliary) buttons.

6. Slide the pin back into the handle attachment.

You will need to hammer it carefully back into place. Make sure the screwdriver does not
rotate or move in relation to the position of the handle during this process.

7. Using a 5/32-in Allen wrench, tighten the fastener on the handle attachment until it

is secure.

You are now ready to use your Pistol Grip screwdriver.

Advertising