SPX Cooling Technologies SD25 - Manual (Page 23)

User’s Manual
June 2004 T-40409-A Page 15
The screwdriver inputs are software selectable using VS. To disable the push-to-start function, assign
the Cycle On input, Cycle Enable input and the Clear Outputs input to the Trigger. The typical inputs
for a screwdriver with push-to-start function disabled are shown below.
Enabling the Push-to-Start Function
Typically, to start a fastening cycle when the push-to-start function on a handheld screwdriver is
enabled:
• Press the throttle/trigger lever to enable the fastening cycle.
• Push down firmly on the screwdriver to start the fastening cycle.
• Release the throttle/trigger lever to stop the fastening cycle.
OR
• Release the pressure on the screwdriver to stop the fastening cycle.