Sterling Plumbing ADA Adaptable Bath and Wall Surrounds 7114 Series - Manual (Page 22)

5. Prepare the Bath and Subfloor
NOTE: To avoid damaging the finish of the bath, make sure that there is a drop cloth
or other protective liner in the bath before proceeding.
NOTE: The bath must be attached using the clips (provided). Ensure the fasteners are
galvanized or plated.
Verify the studs are within 1/8 ″ (3 mm) of the bath at the recommended clip or
roofing nail locations. Shim if necessary.
Refer to the
″Roughing-In″ section for recommended clip locations.
At the side of the stud, position the bottom lip of the clip under the flange of the
bath, as shown.
Slide the clip into place between the center of the stud and the bath.
Use a pliers to bend the tab of the clip over the bath flange.
Repeat these steps for the remaining clips.
Secure the clips to the studs with roofing nails or non-tapered flathead screws.
Use caution to avoid hitting the bath with a hammer.
Préparer la baignoire et le plancher
REMARQUE: Pour éviter tout endommagement de la finition de la baignoire,
s’assurer de la présence d’une toile de protection ou d’un autre revêtement de
protection dans la baignoire avant de continuer.
Nail/Clou/Clavo
Stud/Montant/Poste de madera
Bath/Baignoire/Bañera
Attachment Clip
Clip d'attache
Clip de sujeción
Bath Flange
Bride de la baignoire
Reborde de la bañera
1065823-2-F 22 Sterling