Troubleshooting guide (continued), Additional problems – Shindaiwa 502s User Manual

Page 19

Advertising
background image

19

Troubleshooting Guide (continued)

ADDITIONAL PROBLEMS

Poor acceleration.

Idle speed set too low.

Consult with an authorized servicing

dealer.

Symptom

Possible Cause

Remedy

Engine stops abruptly.

Engine difficult to shut off.

Excessive vibration.

Chain rotates at idle speed.

Broken clutch spring or worn clutch

spring boss.

Warped or damaged sprocket, chain,

or bar.
Bent crankshaft.

Clean or replace the air filter.
Replace the fuel filter.
Inspect and/or test brake. Consult with

an authorized servicing dealer.
Consult with an authorized servicing

dealer.
Adjust: 2,800 min

-1

.

Reset the switch and restart.
Refuel. See section on Filling the Tank

with Fuel..
Replace fuel filter.
Drain; replace with clean fuel. See section

on Filling the Tank with Fuel.

Clean or replace the plug. Check the

Specifications page for the correct spark plug.

Tighten the terminal.
Replace the ignition unit.

Consult with an authorized servicing

dealer.

Test and replace as required.

Replace the plug. Check the Specifications

page for the correct spark plug.

Idle engine until cool.

Set idle: 2,800 min

-1

Replace spring/shoes as required, check

idle speed.

Inspect and replace chain components as

required.

Engine idle too high.

Overheated engine

Overheating due to incorrect spark plug.

Ground (stop) wire is disconnected, or

switch is defective.

Piston seizure.

Clogged air filter.

Switch turned off.
Fuel tank empty.

Clogged fuel filter.

Water in the fuel.

Shorted spark plug or loose terminal.

Ignition failure.

Clogged fuel filter.
Chain brake engaged.

Lean fuel/air mixture.

Advertising
This manual is related to the following products: