Sony Multi-Profile CCD Box Type Network Camera HQ1 - Manual (Page 39)

Network Camera User’s Guide
39/83
System
: Configure and maintain system
Use this menu to perform the principal settings of the device.
System
:
DIPS (Dynamic IP Service):
To enable or disable the DIPS® (Dynamic IP Service) function.
Device ID (for DIPS):
It’s a unique number of each device for identification and this ID is used for DIPS.
In the Appendix H, it describes how to locate your device from Internet by DDNS service.
However, we provide another easier way to do the same job called Dynamic IP Service,
DIPS®.
To use this service, just follow four steps below:
(1) Enable DIPS function of the device
(2) Check your Device ID from this page. This is a unique number for each device.
(3) If your device is behind a NAT router, please configure your device properly. You
could refer to section “Install the Camera behind a NAT Router” above. You only need to
do this job one time.
(4) Check the web site: http://www.a-mtk.com/