Sony Multi-Profile CCD Box Type Network Camera HQ1 - Manual (Page 58)

Network Camera User’s Guide
58/83
Appendix A: Restore Factory
Default Settings
There is a button hidden in the pinhole on the rear panel. This button is used to restore
the all factory default settings. Sometimes restarting the device will make the system
back to a normal state. However, if the system still got problems after restart, user can
restore the factory default settings and install it again.
Restore the device:
1. Insert the paper clip or other suitable tool to press and hold the button down
continuously.
2. Hold it least 3 seconds and release the tool. Then the device has been
restored to default settings and reboot again.
Note: Restoring the factory default setting will lose the all previous settings included IP
address forever. User needs to run the IPWizard program to search the device and
configure it to let the device work properly again.
Factory
Default Reset