Silicon Image silicondvr s1-2k - Manual (Page 11)

© 2008 Silicon Imaging, Inc Page 11
Once the restore operation has completed, which typically takes five to ten minutes, you
will see a message reporting OPERATION IS FINISHED.
Click the large button at the bottom “CLICK HERE TO COMPLETE” to begin the system
shutdown and insure that data written to the internal flash drive is safely stored.
Note: The option to cancel the process once a restore has started is not available. If the
restore process is interrupted, the internal flash drive will be in a corrupted state. Always
wait for the Maintenance Tool to report that the process has completed and allow it to
shut down the system before switching off the power.
Although there are additional capabilities available via the Linux operating system that
underlies the Maintenance Tool, you should only use the options available via the
Maintenance Interface unless directed otherwise by Silicon Imaging.
About 30 seconds after the shutdown process is initiated, after a series of text messages from
the operating system shutting down, you will see a single line indicating “System Halted” and
the stream of text will stop.
At this point, you may switch off power to the SI-2K and remove the Maintenance Tool USB
drive. The snapshot is now restored and you may switch on the power to the SI-2K and verify
that the restoration or upgrade has succeeded.
The SI-2K will power on and go thru one automatic reboot cycle. Upon reboot, the camera will
startup SiliconDVR and ready to shoot.