Silicon Image silicondvr s1-2k - Manual (Page 8)

© 2008 Silicon Imaging, Inc Page 8
A warning message will appear as shown in Figure 2. Verify that the flash drive has been
correctly identified, in this example it’s drive “F:”, and press ENTER to make the drive bootable.
Figure 2
Use the “Safely Remove Hardware” function on the Windows Taskbar to insure that the drive is
properly written prior to unplugging it.
Please note that almost all recently manufactured flash drives from reputable
manufacturers are compatible with the SI-2K’s booting process, but there are a few that
may not work. If you encounter problems in the following steps, you may need to try a
different kind of flash drive. For maximum compatibility, use the drive provided by
Silicon Imaging.