Silicon Image silicondvr s1-2k - Manual (Page 3)

© 2008 Silicon Imaging, Inc Page 3
1.0 Introduction
This manual covers the installation and update procedure for the following:
•
SI-2K Recorders using Maintenance Tool (Section 2)
•
PC/Laptop Systems with Software Installer (Section 3)
The SI-2K Image installation uses a new SI-2K Maintenance Tool to update both SiliconDVR and the full
operating system which resides on the internal Compact Flash. Once updated, no additional software or driver
installation is required. This update procedure overwrites the entire internal flash image and any user files or
custom looks which may have been created, should be backed-up prior to the update procedure.
The SiliconDVR Installer is designed to run on an XP or Vista computers that will be used as the recorder for
SI-2K Mini cameras. The install instructions include those for systems with the following configurations
• Intel High-Performance Pro/1000 NIC
• Generic Gigabit Ethernet NIC systems (eg. Marvell Yukon)
The installer includes all of the licensed software and drivers necessary for operation of the camera. No
additional licenses are required to operate the system. A complete list of new features and enhancements can
be found in Section 1.1.
Check for the most current information on the SI-2K Image and SiliconDVR on our website under ‘Support’.
The address is:
http://www.siliconimaging.com//DigitalCinema/SiliconImaging_support.html
There is an End User License Agreement (EULA) at the end of this document (Section 5). By installing the
software, you have agreed with the terms of this document. Please read it before proceeding.
For additional support, please email: [email protected]