Socket Mobile Cordless Hand Scanner - Manual (Page 16)

• Trigger Operation:
− Scan always: Select if you would like the CHS to scan whether or not
it has a Bluetooth connection to the host device.
− Scan only when connected to host: Select if you would like the CHS
to detect a Bluetooth connection to the host device before it scans.
Scanning will be a few milliseconds slower. This option allows the
CHS to be triggered remotely if needed.
• Good Read Indicator: Select how would like the scanner to indicate that data
has been successfully scanned and transmitted to the host device.
− Beep: If desired, select the KHz of the beep used to indicate good
reads. If operating the CHS in a noisy environment, adjust the KHz
as needed.
− Flash green LED: Check to have the CHS LED flash green to indicate
good reads.
The delay in the ‘good scan’ indicator increases with the
distance from the host, giving the user valuable feedback
about the strength of the connection.
• CHS Battery Level: No progress bar should appear since you have not yet
connected to the CHS. Later, when the CHS is connected to your Pocket
PC, you can return to this utility to view the battery level.
• Disable CHS Auto Power Off mode: By default, the CHS will automatically
shut off if no Bluetooth connection has been established for 20 minutes.
Check the box to disable this mode.
5. After modifying any settings, tap ok. If you enabled the Flash green LED
setting, the CHS will beep once to confirm. If SocketScan is already
open, you must close and reopen SocketScan for the changes to take
effect.
16