Sony CHC-TB20 - Manual (Page 21)

Tape/Sound Adjustment
21 GB
To Do this
Sound Adjustment
Activate/check
the setting Press CLOCK/TIMER
SELECT on the remote and
press . or > on the
remote to select “REC
SELECT?”, then press
ENTER/YES.
Change the setting Start over from step 1.
Cancel the timer Press CLOCK/TIMER
SELECT on the remote and
press . or > on the
remote to select “TIMER
OFF”, then press ENTER/
YES.
Notes
• When you use the recording timer at the same time
as the Sleep Timer, the Sleep Timer setting has
priority.
• You cannot activate the Daily Timer and the
recording timer at the same time.
• The system automatically turned on about 30
seconds before the preset time. Do not operate the
system until the recording starts.
• If the system is on about 30 seconds before the
preset time, the timer-recording will not be
activated.
• The volume is reduced to minimum during
recording.
Adjusting the sound
Enjoying the powerful sound
— GROOVE
You can listen to music with more powerful
sound.
Press GROOVE.
“GROOVE” appears in the display and the
volume switches to power mode (DBFB is also
turned on).
Press again to cancel GROOVE.
DBFB is also canceled.
Tip
GROOVE is factory set to on.
Reinforcing the bass sound
— DBFB
You can listen to music with stronger bass
tones.
Press DBFB * .
“DBFB” appears in the display and the bass is
reinforced.
Press again to cancel DBFB.
* DBFB: Dynamic Bass Feedback
Tip
DBFB is factory set to on.
Selecting the surround effect
Press SURROUND.
“SURROUND” appears in the display.
Press again to cancel SURROUND.