Sony CHC-TB20 - Manual (Page 24)

24 GB
Waking up to music (continued)
Display
8
Press ENTER/YES.
The start time, the stop time, and the sound
source appear in turn, then the original
display returns.
9
Press ?/1 to turn off the system.
To Do this
Activate/check the
setting Press CLOCK/TIMER
SELECT on the remote, then
press . or > on the
remote until “DAILY
SELECT?” appears. Then,
press ENTER/YES.
Change the setting Start over from step 1.
Cancel the timer Press CLOCK/TIMER
SELECT on the remote, then
press . or > on the
remote until “TIMER OFF”
appears. Then, press ENTER/
YES.
Notes
• If the system is on about 30 seconds before the
preset time, the Daily Timer will not be activated.
• The system automatically turns on about 30 seconds
before the preset time. Do not operate the system
until the play starts.
• You cannot activate the Daily Timer and the
recording timer at the same time.
Turning off the display
— Power Saving Mode
The demonstration display (display window
and buttons lighting and flashing even when
the system power is off) and the clock display
can be turned off to minimize the amount of
power consumed during standby (Power
Saving Mode).
Press DISPLAY repeatedly while the
system is off until the demonstration
display or the clock display disappears.
To cancel the Power Saving Mode
Press DISPLAY while the system is off. Each
time you press the button, the display switches
cyclically as follows:
Demonstration display t Clock display* t
No display (Power Saving Mode)
* “--:--” is displayed if you do not set the clock.
Tips
• ?/1 indicator lights up even in the Power Saving
Mode.
• The timer continues to operate in Power Saving
Mode.
Adjusting the brightness
of the display back light
1
Press DIMMER while the system is on.
2
Slide the knob to l or to L (or
press . or > on the remote) to
adjust the back light brightness.
You can adjust the back light brightness in
11 steps from 0 to 10.