Sony Cyber-shot DSC-G1 - Manual (Page 70)

70
Settings For details on the operation
1 page 54
Network
The default settings are marked with .
z MAC address
A unique MAC address as a wireless device is assigned to each camera. Certain access point may require to
register your MAC address onto the access point to permit a connection. For details, refer to the operating
instructions of your access point.
Creates or edits the profile of the wireless LAN access point.
Normally, the setup of an access point is performed with [Auto Scan]. If the access point
cannot be detected, follow the procedure below.
Up to three profiles can be registered.
To set up an access point
1 Select [Access Point] with the control button, then press z.
2 Select [New Connection], then press z.
3 Select [Manual Settings], then press z.
The setup screen appears.
4 Set up the following items.
Access Point
Connection Enter a connection name. Up to 16 characters can be used.
SSID Enter the service set identifier of the access point. Up to 32
characters can be used.
Encryption Select one of the following encryption modes: [Disabled],
[WEP], [WPA-PSK(TKIP)], and [WPA2-PSK(AES)]
Password Enter the password. Up to 64 characters can be used.
MAC address