Sony DVS-9000 - Manual (Page 266)

Chapter 7
F
rame Memor
y
C:\WINNT\Profiles\Administrator\Desktop\WORK_08_21\370467401
DVS9000WW\01GB09C07-WW.fm masterpage:Left
266
Frame Memory Operations
DVS-9000/9000SF
3-704-674-01 (1)
Frame Memory Operations
For an overview of frame memory concepts, see “Frame Memory” (page 61).
Preparations
Allocating the frame memory outputs (FM1 to FM8) to cross-
point buttons
To output a frame memory image to a monitor, for example, the output signal
from the frame memory (FM1 to FM8) must be allocated to a cross-point
button. Carry out this allocation in the Setup menu.
Accessing the Frame Memory menu
Most frame memory operations are carried out using the Frame Memory menu.
To access the Frame Memory menu, use either of the following procedures.
• In the menu control block, select the top menu selection button [FRAME
MEM].
• Press the cross-point button to which the frame memory output is allocated
twice in rapid succession.
Input Image Selection
For the input image to frame memory, you can use either the signal selected on
one of the two frame memory source buses or a dedicated color matte signal.
When using the signal on frame memory source bus 1 or 2 for the input image,
select the signal as described below.
For the method of using a color matte signal, see “Freezing an image and
writing it to memory” (page 267).
Selecting the signal on a frame memory source bus
As an example, to select a signal on frame memory source bus 1, use the
following procedure.
1
Using the bank selection buttons in the auxiliary bus control block, select
the desired bank.