Sennheiser S-MCD 3000 HP - Manual (Page 50)

50
1 Introduction
The Sennheiser SMCD software gives professional users a modern, advanced way of controlling several
EM 3532 twin receivers in a simple and convenient way.
The Sennheiser SMCD software allows you to handle and control up to 126 EM 3532 receivers. You
can program entire sequences of scenes with several actors without changing the transmitter/receiver
unit. Every actor keeps his transmitter and can be cut in when necessary. During use you can monitor
battery status, VU level and transmitting frequency. You can also change the frequency if necessary.
Basic functions such as opening, saving or closing files correspond to the respective Windows functions
and are assumed to be known. For this reason, they are only mentioned in passing.
The software consists of two different operating modes.
Ǡ You can edit the production in the “Scene Configuration” mode. You can insert, delete and edit
scenes and control panels as required. Transmission between PC and receiver is not possible in this
mode.
Ǡ Transmission between PC and receiver is possible in the “Production” mode. Here you can change
the scenes and cause the different states of the receiver to be indicated at the push of a button. In
order to edit the scenes and control panels, it is necessary to change back to the “Scene Configuration”
mode.
2 Hardware requirements
In order to use the SMCD software, your computer must meet the following minimum requirements.
Ǡ Operating system: Windows 3.11 or Windows 95
Ǡ Processor: at least Pentium with at least 120 MHz or a comparable processor
Ǡ Main memory: at least 16 MB
Ǡ Free hard disk capacity: at least 2 MB