Sennheiser S-MCD 3000 HP - Manual (Page 72)

72
Ǡ Start
You start a recording via the “Start” button. All control elements of the RF recorder excepting the
“Start” button are locked during recording.
Ǡ Recording Type
Select between two recording types via the selection list on the right-hand side of the selection list.
The default is “continued”, which allows continuous recording. If the recording limit is reached
during recording, recording recommences until you terminate it. If you select the recording type
“single mode”, recording stops once the recording limit is reached.
Ǡ Stop
This button allows you to terminate a recording once started. The locked control elements are
made accessible again and you can analyze the measured data.
Ǡ Memory On/Off
You can make a measuring curve previously stored via “Copy to Mem” appear or disappear. This
for example allows two recordings to be compared. The current state (On or Off ) is displayed in
the frame above the button.
Ǡ Copy to Mem
Here you can temporarily save a recorded measuring curve in the memory. You can lay the stored
measuring curve behind a new recording, for example in order to compare both recordings.
Ǡ Zoom
The zoom bar gives you information on the current display range with regard to the entire measuring
range. The grey bar represents the visible field in the recording window. If the entire measuring
range is displayed, the whole of the zoom bar has a grey background.
Ǡ Recording window
The recording window displays the measured data as a function of mode selected and the display
range. In addition, a temporarily stored measuring curve can be laid behind the active measuring
curve for the purposes of comparison.