Sennheiser S-MCD 3000 HP - Manual (Page 62)

62
Frequency list:
You can read the frequencies and channels in question from the list.
Remote:
The “Remote” button allows you to switch off the operating controls on the receiver. The latter
can then only be controlled via the PC.
Standby:
The receiver is put into Standby mode by means of the “Standby” switch.
Booster F.:
The “Booster F.” button allows you to switch on the supply voltage for a connected antenna
booster.
Scan Up / Scan Down:
The “Scan Up / Scan Down” buttons allow you to search for available transmission frequencies.
When a frequency is found, it appears in the text field above the scan functions. If you wish to take
over the frequency, first press “Place” and then “Transmit”.
NOTE
The scan function must always be terminated by pressing the “Stop” button.
2 Setting a new frequency on the receiver
1. Click onto the desired frequency in the frequency list.
2. Click onto the “Transmit” button in order to set this frequency on the receiver.