Sony CMT-EX100 - Manual (Page 19)

Additional Information
19
The timer does not function.
• Press CLOCK/TIMER SELECT on the remote to
set the timer and light up “DAILY” in the
display (see page 16).
• Check the set contents and set the correct time
(see page 16).
• Cancel the Sleep Timer function (see page 15).
The remote does not function.
• Remove the obstacle.
• Move the remote closer to the system.
• Point the remote at the system’s sensor.
• Replace the battery.
• Locate the system away from the fluorescent
light.
CD Player
The CD tray does not lower.
• Place the CD vertically in the tray.
• Always lower the tray by touching OPEN/
CLOSE Z or pressing OPEN/CLOSE Z on the
remote.
The CD does not eject.
• Consult your nearest Sony dealer.
Play does not start.
• Wipe the CD clean (see page 18).
• Replace the CD.
• Place the CD vertically in the tray.
• Place the CD in the tray with the label side front.
• Remove the CD and wipe away the moisture on
the CD, then leave the system turned on for a
few hours until the moisture evaporates.
• Press NX (or CD N on the remote) to start
play.
The sound skips.
• Wipe the CD clean (see page 18).
• Replace the CD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the system,
or placing them on separate stands.
• When you listen to a track with bass sounds at
high volume, the speaker vibration may cause the
sound to skip.
Play does not start from the first track.
• Press PLAY MODE on the remote repeatedly
until “PGM” and “SHUF” disappear to return to
normal play.
Optional components
There is no sound.
• Refer to General item “There is no sound.” on
page 18 and check the condition of the system.
• Connect the component properly (see page 16)
while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions included with
the connected component and start playing.
The sound is distorted.
• Set the volume of the connected component
lower.
continued