Sony CMT-EX100 - Manual (Page 20)

20
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (see page 12).
• Connect the antenna properly (see page 7).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend
you connect a commercially available external
antenna.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
• Try turning off surrounding electrical
equipments.
• Remove the FM antenna from the rear panel and
place the antenna outside the cabinet. Adjust the
antenna.
A stereo FM program cannot be received in
stereo.
• Press FM MODE until “STEREO” appears in the
display.
• See “Severe hum or noise/stations cannot be
received.”, and check the antenna condition.
If the system still does not operate
properly after performing the above
measures, reset the system as
follows:
1 Unplug the power cord.
2 Hold down ?/1 , then plug the power cord
into the wall outlet again.
The system is reset to the factory settings. All
the settings you made such as the preset
stations, clock, and timer are cleared and must
be set again.
Messages
One of the following messages may appear or
flash in the display during operation.
CD
NO DISC
There is no CD.
OVER
You have reached the end of the CD while
pressing M during play or pause.
STEP FULL
You tried to program 25 or more tracks (steps).
Troubleshooting (continued)