Sony CMT-EX100 - Manual (Page 8)

8
3
Slide the battery case back in.
Tip
When the remote no longer operates the system,
replace the battery with a new one.
Notes
• If you do not use the remote for a long period of
time, remove the battery to avoid possible damage
from battery leakage.
• Keep the lithium battery out of the reach of
children. Should the battery be swallowed,
immediately consult a doctor.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommend by the manufacturer. Discard used
batteries according to the manufacturer’s instructions.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
A lithium battery CR2025
Replacing the battery in
the remote
1
Slide out and remove the battery case.
2
Insert a new lithium battery CR2025
with the + side facing up.
Setting the time
1
Turn on the system.
2
Press CLOCK/TIMER SET on the
remote.
Proceed to step 4 when you set the clock for
the first time.
3
Press . or > repeatedly to select
“CLOCK SET”, then press ENTER on
the remote.
The day indication flashes.
4
Press . or > repeatedly to set the
day, then press ENTER on the remote.
The hour indication flashes.
5
Press . or > repeatedly to set the
hour, then press ENTER on the remote.
The minute indication flashes.
6
Press . or > repeatedly to set the
minute, then press ENTER on the
remote.
The clock starts working.
Tip
If you made a mistake or want to change the time,
start over from step 1.
Turning off the clock display
in standby mode
Press DISPLAY on the remote while the
system is off.
To turn on the clock display, press DISPLAY
on the remote again.
Notes
• When the Daily Timer is set, you cannot turn off the
clock display.
• The clock display will appear when you set the
Daily Timer during turning off the display.