Studer Innotec HPC4024 - Manual (Page 11)

STUDER INNOTEC HP-COMPACT
User manual HP-COMPACT V3.0 E 11
riously damage the HP-COMPACT. For instance the connection of a 24 V battery with the
HP-COMPACT 2512.
If by mistake the HP-COMPACT has been wrongly been connected (reverse battery polar-
ity) it is likely that the internal protection fuse has melted and has to be replaced. In that
case it is necessary to disconnect all connections to the HP-COMPACT, including the bat-
tery. If after the fuse replacement and after re-connection of the battery with the right polar-
ity, the HP-COMPACT remains out of order, it must be brought back to your merchant for
service.
3.6.2 Connection to the 230Vac-consumer appliances (AC OUTPUT)
The 230V consumer appliances must be connected to the terminals AC OUTPUT with ca-
bles which cross section has to follow the local rules in force (usually 2,5mm
2 ). Connec-
tions are marked as follows “N“ Neutral, “PE“ Earth (connected to the appliance box), “L“
Live.
Caution: High voltages can be there. Make sure that the HP-COMPACT is turned off (LED
13 lighting) before the connection.
3.6.3 Connection to the 230Vac Input (AC INPUT)
The 230V-supply from network or from a generator must be connected to the input termi-
nals AC INPUT with cables which cross section depends on the power source (usually
2,5mm
2 ). Connections are marked as follows: “N“ Neutral, “PE“ Earth, “L“ Live (connected
to the appliance case).
3.6.4 Connection to Auxiliary Contact
This contact is a potential free change over contact The currents and voltages allowed for
this contact are max. 16A/250Vac. The LED 5 “Contact active” shows the position of them:
alight mind active and off mind non-active. The schematic view of the connections on the
front, show the relay in the non-active mode.
3.6.5 Connection to Remote control
The Remote Control RCC-01 is connected in the terminal marked „Remote control“ with a
20m long cable and a RJ11/8 connector. The Remote Control can be plugged IN or
plugged OUT during any operation situation. Push in the connector softly until you hear the
„click“ showing that the connector is locked. The same applies to the plug in the Remote
Control.
The length of the cable for Remote Control should not exceed 40m. We deliver it with 20m
cable.
3.6.6 Connection to Temperature Sensor (Temp.)
The temperature sensor CT-35 is connected in the terminal marked „Temp“ with a 3m long
cable and a RJ11/6 connector. The temperature sensor can be plugged IN or plugged
OUT during any operating situation. Push in the connector softly until you hear the „click“
showing that the connector is locked. The temperature sensor must be glued to the wall of
the battery or near it. The Temperature Sensor cable must not be tied together with the
battery cables or laid in a rope/bundle.
3.6.7 Connection to the Remote Control for the „Power Sharing“ (RPS-01)
This remote control is connected with a 20m long cable and a RJ11/6 connector in the
connection terminal „F“ (Temp. sensor). It can be connected and disconnected at any time.
Push in the connector softly until you hear the „click“ showing that the connector is locked.
In case the remote control is connected together with the Temp. sensor, a short cable with
a Y-connector will be connected in the terminal „F“ (can be supply as an option).