Sony DVP-LS785V EN - Manual (Page 56)

56
◆VIRTUAL MULTI REAR
Creates an array of virtual rear speakers from
a single set of actual rear speakers.
The position of the virtual rear speakers
differs according to “REAR” or “SIDE”
setting of the rear speakers (page 87).
◆VIRTUAL MULTI DIMENSION
Creates an array of virtual rear speaker
positions higher than the listener from a
single set of actual rear speakers.
This mode creates five sets of virtual speakers
surrounding the listener at approximately a
30
° angle of elevation. The effect differs
according to “REAR” or “SIDE” setting of
the rear speakers (page 87).
Notes
• When you select one of the surround modes, turn
off the surround setting of the connected TV or
amplifier (receiver).
• Not all discs will respond to the “TVS NIGHT”
function in the same way.
• To enjoy the multichannel audio through the
5.1CH OUTPUT jacks, correctly set each speaker
position and distance (page 26, 87).
• When the playing signal does not contain a signal
for the rear speakers, you cannot hear the TVS
effect.
• When you select one of the TVS modes, the
player does not output the sound of centre
speaker.
• Make sure that your listening position is between
and at an equal distance from your speakers, and
that the speakers are located in similar
surroundings.
• If you use the DIGITAL OUT (OPTICAL or
COAXIAL) jack and set “DOLBY DIGITAL” to
“DOLBY DIGITAL,” “DTS” to “DTS,” and
“MPEG” to “MPEG” in “AUDIO SETUP,”
sound will come from your speakers but it will not
have the SURROUND effect.
L
LS RS
R
L R
LS RS
REAR
SIDE
LS RS
L R
L R
LS RS
REAR
SIDE
L: Front speaker (left)
R: Front speaker (right)
LS: Rear speaker (left)
RS: Rear speaker (right)
: Virtual speaker