Silex technology Multicast Video Distribution System MVDS X-1 - Manual (Page 49)

3.Monitor and Maintenance
43
VIDEO CONFIG
Shows or Configures the video settings.
VIDEO CONFIG (sample)
CAPTURE GAIN *
R 128 G 128 B 128 Selected menu
Current setting of the selected menu
Menu Information
AUTO CONFIG Starts the auto-adjustment for image parameters.
By pushing [SET] button, you can switch to the auto-adjustment screen.
Push [ + ] and [ - ] buttons to select [OK] (the current setting is enclosed with [ ]).
Push [SET] button to start auto-adjustment.
VGA CONFIG
CANCEL [ OK ]
Select [OK].
The result is displayed in the lower line of LCD. The definition of each message
is as follows:
Message Status
COMPLETE & SAVED Suceeded in VGA auto-adjustment.
ERR: OUT RANGE Failed in VGA auto-adjustment.
Incorrect VGA signal is input.
Check that the resolution and refresh note
settings are respectively set to "1280x768" and
"60Hz" in the player(s).
ERR: NO VGA IN Failed in VGA auto-adjustment.
VGA signal is not input.
Check that a VGA cable is properly plugged
in or player(s) have proper settings to output
video signals.
ERR: SCAN FAILED Failed in VGA auto-adjustment.
Play another movie or still image at the
player(s) and try the auto-adjustment again.
ERR: N/A VGA auto-adjustment unavailable
VGA auto-adjustment is not available while
this product is sending a maintenance screen.
Stop sending a maintenance screen and try the
auto-adjustment again.