Servis-Rhino F-4123C - Manual (Page 44)

ASSEMBLY
1585 01/11 Assembly Section 3-10
© 2011 Alamo Group Inc.
ASSEMBL
Y
Attaching Valve Mounting & Valve
1. Attach valve mounting stand on inside of right mid mount using M10 x 45 mm bolts, lockwashers, and hex
nuts.
2. Attach valve to valve mounting stand with M8 x 50 mm bolts, lockwashers, and hex nuts. AsmP-L-0001
Attaching Tractor Hydraulic Block
1. Remove cover from tractor hydraulic area
located under foot rest on right side of tractor.
Align attaching holes in tractor with holes in
hydraulic block. Install hydraulic block with O-
rings in place using (4) bolts, lockwashers, and
O-rings. (2 ports are on top & one port to lower
front of tractor).
2. Install 90º pipe hydraulic elbow fitting in top
front pressure port and point toward front of
tractor.
3. Install straight pipe adapters into other two
ports. (Figure Asmp-L-0002).
Hose Plumbing
1. Connect pressure hose from top front 90º elbow fitting on tractor hydraulic block to valve 90º elbow fitting
left inlet on valve. (P Port).
2. Connect tank hose with tube 90º bend from hydraulic block lower front port (tank port) to 90º elbow fitting
on front of valve. (T Port).
3. Connect power beyond hose with tube 90º bend from hydraulic block rear upper port (power beyond) to
90º elbow fitting on valve (on right side of valve). (See Figure AsmP-L-0002).