Sanyo AHX0752 - Manual (Page 62)

2-42
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Remote Control Functions
2
1 4 5
3
NOTE:
The temperature on the remote controller is displayed
in Celusis (C).
Please note that you will not mistakenly read it
in Fahrenheit (F) on the display.
Sensor Temperature Diaplay
3. Timer Remote Controller (RCS-TM80BG)
02 Intake temp.
03 E1
04 –
05 E3
06 Discharge temp.
07 Discharge temp. setting
08
Position of indoor unit
Motor Operated Valve (MOV)
0A 2A 4A 6A
0B 2B 4B 6B
0C 2C 4C 6C
0D 2D 4D 6D
0E 2E 4E 6E
0F 2F 4F 6F
10 30 50 70
11 31 51 71
12 32 52 72 —
— 13 33 53 73
14 34 54 74
15 35 55 75 —
16 36 56 76 —
17 37 57 77
18 38 58 78
19 39 59 79
1A 3A 5A 7A
1B 3B 5B 7B —
1C 3C 5C 7C —
—
—
—
1D 3D 5D 7D
1E 3E 5E 7E
1F 3F 5F 7F
20 40 60 80
21 41 61 81
22 42 62 82
Discharge temp. 3
Outdoor air temp.
CT2
CT3
Low-pressure sensor temp.
Suction temp.
Oil 1
Oil 2
Oil 3
Heat exchanger liquid 1
Heat exchanger gas 1
Heat exchanger liquid 2
Heat exchanger gas 2
High-pressure sensor temp.
Discharge temp. 2
Discharge temp. 1
■ Sensor Temperature Display Function
(displayed regardless of whether unit is
operating or stopped)
The procedure below displays the sensor tempera-
tures from the remote controller, indoor unit, and out-
door unit on the remote controller.
<Procedure>
Press and hold the and buttons
simultaneously for 4 seconds or longer.
The unit No. “X-X” (main unit No.), item code “XX”
(sensor address), and servicing monitor “ XX”
(sensor temperature) are displayed on the remote
controller LCD display.
Press the temperature setting /
buttons and select the item code to the address of
the sensor to monitor.
(For the relationships between the sensor
addresses and sensor types, refer to the table of
temperature sensors and addresses below.)
If group control is in effect, press the
button to select the unit to monitor.
Press the temperature setting buttons
to select the item code to change.
Press the button to return to
normal remote controller display.
NOTE
The temperature display appears as “- - - -”
for units that are not connected.
* If monitor mode is engaged while normal
operation is in progress, only the parts of
the LCD display shown in the figure will
change. Other parts continue to display
the same information as during normal
operation.