Sennheiser 2015 - Manual (Page 44)

96
̈
Press the SET button to store your setting.
Entering a name
NAME Via the “ NAME ” menu, you can enter a freely selectable name for the trans-
mitter or receiver. This name is briefly shown on the display panel after
switch-on.
The name can consist of up to six characters such as:
y
letters (without pronounciation marks),
y
numbers from 0 to 9,
y
special characters e.g. () - . _ and spaces.
To enter a name, proceed as follows:
After you have entered into the setting mode of the menu, the first seg-
ment starts flashing on the display.
̈ Use the ̆ / ̄ rocker button (UP/DOWN) to select a character. By briefly
pressing the button, the display jumps either forwards or backwards to
the next character. If you hold down the button, the display starts cyc-
ling continuously.
̈ Press the SET button to change to the next segment.
̈
After you have entered the name completely press the SET button to
store your setting and to return to the top menu level.
Resetting the unit to the factory-preset default settings
RESET Via the “ RESET ” menu, you can reset the unit to the factory-preset default
settings. In order to prevent an accidental reset, a safety query appears on
the display. You can select “NO” or “OK”.
y
“NO”: If you select “NO” and confirm your selection by pressing the
SET button, the reset of the unit is cancelled and you return to
the configuration menu.
y
“OK”: If you select “OK” and confirm your selection by pressing the
SET button, the unit is reset to the factory-preset default set-
tings. After the reset, the unit is restarted and “SETUP”
appears on the display.