Source Technologies 1352 MICR 40 - Manual (Page 25)

Secure MICR Printer User’s Guide
©
Source Technologies
July 2003 Page 21 All rights reserved
In order to set a new password the current password must first be sent. Caution: Errors made
in sending the new password command could lead to setting it to an unknown value. If the
Password is unknown the printer must be returned to Source Technologies to be reset to
PASSWORD.
Activate/Set Front Panel Combination Lock &%STSxxxxxxxx$ (optional)
&%STS Lead in sequence
xxxxxxxx Eight digit sequence, valid characters 0-9
$ Command terminator
Sets and activates the front panel MICR combination lock. If this feature is activated, MICR
mode cannot be entered until the front panel combination is entered correctly. All MICR
features will be inaccessible until this combination is entered. Sending an &%STS
command and eight zeros deactivates the security lock.
Caution: If the front panel combination is set and then forgotten, the printer must be
returned to Source Technologies for the combination to be deactivated.
Print MICR E-13B Font &%SMDddd...ddd$
&%SMD Lead in sequence
ddd...ddd Data to be printed in E-13B MICR font
$ Command terminator
Prints the specified data in the E-13B MICR font which is used in the United States,
Canada and Mexico. The correct spacing begins at the cursor position at the start of the
command. After the terminator is sent, the printer is returned to its default font. After each
Print E-13B command, the MICR count is decremented by one. Upon receiving this command
the printer will check to ensure a MICR toner cartridge is installed and set the copies
parameter to 1. See Appendix A for MICR E-13B font character mapping.
Print MICR CMC7 Font &%SM7ddd...ddd$
&%SM7 Lead in sequence
ddd...ddd Data to be printed in CMC7 font
$ Command terminator
Prints the specified data in the CMC7 MICR font which is used in Europe and South America.
The font and its correct spacing begins at the current cursor position at the start of the
command. After the terminator is sent, the printer will return to its default font, and the MICR
count will be decremented by one. Upon receiving this command the printer will check to
ensure a MICR toner cartridge is installed and set the copies parameter to 1. See Appendix B
for CMC7 character mapping.
Section 6: MICR Features