Stellar Industries SI-60 - Manual (Page 43)

37 Installation 37
Position fender to allow
for max air bag travel
and spring compression.
Position fender to allow
for max walking beam
travel.
Position fender to allow adequate
clearance between fender & hydraulic
cylinder in upright extended position.
0.25” Weld Around
(6 Places)
Rear Fender
Tube Weldment
Fender
Weldment
1/2NC x 2” Square
Head cone Point
Set Screw
1/2NC Hex Nut
5/8NC x 5” GRD5
Cap Screw Fender
Connector:
Weld into place with five (5) 1” welds after
fenders and bumpers have been installed.
Front
Fender
Tube Weldment
Front Fender
Tube Weldment
End Cap
5/8” Std. Flat Washer
Fender
Weldment
End
Cap
5/8NC Self Locking Nut
Gusset
Spacer
1” x 2.5” x 2.5”
Steel Tandem/Tri-Axle
Step 12a: Fender Installation - Steel Tandem/Tri-Axle