Displaying total number of copies, Displaying total number of, Copies – Sharp AR-203E User Manual
Page 46: P.44)
44
* Factory default settings are indicated with an asterisk (*).
5
Press the start (
) key. The right-hand number in the display
will be steadily lit and the entered value will be stored.
6
Press the light (
) key to return to the normal copy mode.
DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
1
Press and hold down the clear (
) key for approximately 5 seconds.
The total number of copies will appear in two steps, each with three
digits.
Example: Total number of copies is 1,234.
6
SPF automatic
original discharge
time (if installed)
1
5 min., *2
30 min.,
3
60 min., 4
120 min.,
5
240 min., 6
OFF
10
Resolution of AUTO
& MANUAL mode
*1
300dpi, 2
600dpi
21
Reset factory
1
YES, *2
NO
24
Prevention of OC
copies when the
SPF is up function
*1
ON,
2
OFF
25
Copy effective paper
width setting function
(Bypass tray)
*1
Large (A4 width),
2
Small (B5R width)
26
Copy effective paper
width setting function
(Tray 1)
*1
Large (A4 width),
2
Small (B5R width)
27
Copy effective paper
width setting function
(Tray 2 if installed)
*1
Large (A4 width),
2
Small (B5R width)
28
Selection of copy
start state (Polygon
rotation on/off)
*1
ON,
2
OFF
29
Fusing temperature
setting when the
bypass tray is used
1
Low,
*2
High
To change the setting or to set another mode, press the clear
(
) key. The unit will return to step 2.
Program
No.
Mode
Parameters