Siemens CX203isdn - Manual (Page 104)

103
System settings
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / settings_bs.fm / 14.11.2005
Setting up ring delay
Ring delay can be used to individually set one subscriber per receive MSN to ring later.
However, during this ring delay time, the terminal can answer the call using the
"Accept?" function without hearing a ring. The ring delay time is specified in ring
cycles. A ring cycle lasts 5 seconds.
The default setting is 0 ring cycles (= not activated).
Take into account the response time of the answering machine when making this
setting (default: Automatic 2/4). If the set ring delay is longer than the setting for an
active answering machine, the phone will not ring because the answering machine will
pick up the call first.
For each programmed MSN, at least one subscriber must be able to be called
immediately. Therefore, a subscriber for which ring delay is set up will be called
immediately if it is the only one on this receive MSN, or none of the others can be
reached on this receive MSN.
Picking up a call during ring delay, see page 23.
i
Open the menu.
s
Set base Select the menu item and confirm.
s
Settings Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
Setup user
Select the menu item and confirm.
s
Setup device
Select the menu item and confirm.
s
INT11: Int.11
W Select internal number and open submenu,
e.g. INT11: Int.11.
s
Ring delay
Select the menu item and confirm.
s
MSN1:
Select the receive MSN and confirm,
e.g. MSN1: Anna.
~
No. of rings enter and confirm, e.g. 2.
OK
OK
OK
OK
OK
OK
OK
OK