Siemens CX203isdn - Manual (Page 127)

126
Operating when connected to a PABX
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / pabx.fm / 14.11.2005
Activating/deactivating the keypad during a call
In addition to the ongoing settings described above, you can also switch over
temporarily to the keypad.
The setting is only applicable to the current external call and is automatically
deactivated after the call is ended.
During a call:
Activating the keypad for the next connection
All dialling characters (0–9, *, #) will be sent as a string of keypad characters with the
next connection (dial and call). In the connection status, the keypad is retained and is
not automatically switched over to tone dialling (DTMF).
i
Open the menu.
s
Set base Select the menu item and confirm.
s
Settings Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
System settings Select the menu item and confirm.
s
Spec. function Select the menu item and confirm.
s
Dial properties Select the menu item and confirm.
s
Standard dial Select the setting and confirm, e.g. Standard dial
(
‰
= activated).
OK
OK
OK
OK
OK
OK
OK
i
Open the menu.
either ... Activate the keypad:
s
Keypad on?
Select the menu item and confirm.
~
Enter the keypad code.
or ... Deactivate the keypad:
s
Keypad off?
Select the menu item and confirm.
OK
OK
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Call preparat.
Select the menu item and confirm.
s
Temp. keypad
Select the menu item and confirm (
‰
= activated).
OK
OK
OK