Sony AEP MODEL CPD-E200E - Manual (Page 15)

CPD-E200E
2-5. H BOARD REMOVAL
1 Screw
(+BVTP 4 x 16)
3 Claw
4 H board
Picture tube
Bezel
Cushion
5 Menu button
2 H bracket
3 When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow
c .
• HOW TO HANDLE AN ANODE-CAP
1 Don’t scratch the surface of anode-caps with shartp shaped mate-
rial!
2 Don’t press the rubber hardly not to damege inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3 Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or damage the rubber.
a
b
Anode Button
c
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,
after removing the anode.
• REMOVING PROCEDURES
1 Turn up one side of the rubber cap in
the direction indicated by the arrow
a .
2 Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow
b .
2-4