Speaker crossover menu, Chapter 4, Crossover adjustment – Sunfire TGP-5 User Manual

Page 41: Subwoofer mode

Advertising
background image

User's Manual

41

CHAPTER 4

MAIN MENU

TRIMS

MODES

TONE

INPUTS

SETTINGS

SETTINGS

MAIN ZONE

ZONE 2

SPEAKERS

VIDEO

SOFTWARE

CONTROL

Speaker Crossover Menu

Crossover adjustment

The TGP-5 bass management

system allows you to send the low
frequencies of your speakers to a
subwoofer. The crossover point of
your main left and right speakers can
be selected from 40 Hz to 160 Hz, as
can the crossover point of your center
and surround speakers.

For example, if your main left and

right speakers are a bit lacking in bass
response, you can set the speaker
size to SMALL, and set the L-R cross-
over to 40 Hz. The subwoofer will then
receive the lower bass range, (not
well reproduced by your front speak-
ers). This will not affect the range sent
to your center or surrounds.

A setting of 80 Hz is a good start-

ing point if you are not sure of the
response of your speakers. In this
example:

• The subwoofer receives frequen-

cies below 80 Hz, from all speak-
ers whose size is set to SMALL.

• All speakers set to SMALL, receive

frequencies above 80 Hz.

SPEAKERS

SIZE

POSITION

CALIBRATION

L-R CROSSOVER

80 HZ

C-SURR CROSSOVER

80 HZ

SUBWFR MODE ENHANCED BASS

Subwoofer Mode

The subwoofer output can be set

to Normal, or to an Enhanced Bass
mode.

The Enhanced Bass mode provides

an output to your subwoofer even
when you are listening to a stereo
source with main speakers set to
LARGE. In the Normal mode, there
would be no subwoofer output in this
case, and the bass would only come
from the main speakers.

The Enhanced Bass mode has no

effect if the main speakers are set to
SMALL, as the subwoofer is automati-
cally engaged. It also has no effect in
5.1 or greater surround modes.

Most manufacturers provide a -3 dB

specifi cation for their speakers. This
is the frequency where the speaker's
output has dropped by 3 dB. Set the
TGP-5's crossover to this frequency or
above. If you cannot fi nd this, set the
crossover to 80 Hz (the default).

Set your subwoofer's own cross-

over control to maximum frequency or
bypassed mode. If it is set lower than
the TGP-5, there would be a hole in
the mid-bass, and bass information
would be missing.

Advertising