Quick start, Before you start, Software required – Sierra Wireless RJ-11 User Manual
Page 10: Hardware required
Rev 3.0 B 2/15/08
5
2: Quick Start
•
•
•
Address and
Interface Port of the
RJ-11 RJ-11 IP
Gateway Defaults
Configuring the RJ‐11 IP Gateway to work with your Sierra
Wireless Airlink Raven X and vice‐versa is easy. This chapter
covers a basic configuration. For more advanced configuration
of your Raven X, refer to the modem’s user guide. The
complete configuration options for the RJ‐11 IP Gateway are in
this guide.
Before You Start
Software Required
•
AceManager ‐ Graphical interface for configuring your
Sierra Wireless AirLink
modem
. AceManager is located on
all modem the CDs or you can download AceManager
from the Sierra Wireless website:
http://
www.sierrawireless.com
. A default installation of this
utility is assumed later in these directions.
Hardware Required
•
Ethernet Cable ‐ The RJ‐11 IP Gateway and Raven X have
an auto‐sensing Ethernet port, you can use either a cross‐
over cable or a straight‐through Ethernet cable.
•
Power adapters and a power source ‐ You will need a
power adapter and power source for both the RJ‐11 IP
Gateway and the RavenX.
Note: If you are using a Raven-E, you may need a cross-over cable
to connect to the RJ-11 IP Gateway.
•
PC or Laptop ‐ To configure both the RJ‐11 IP Gateway
and the device, you will need a computer with Internet
Access, other than the cellular account, and an available
Ethernet port.