Sennheiser SKM100 - Manual (Page 13)

12
Using the radio microphone
Using the radio microphone
To establish a transmission link, proceed as follows:
1. Switch the receiver on
(see the instruction manual of the receiver).
2. Switch the radio microphone on (see next section).
The transmission link is established and the receiver’s
RF level display “
RF ” reacts.
If you cannot establish a transmission link between radio
microphone and receiver, refer to the chapter “Synchro-
nizing the radio microphone with a receiver” on page 25.
Switching the radio microphone on/off
To switch the radio microphone on (online operation):
CAUTION! Reduced transmission range
If you touch the antenna
¶
of the radio micro-
phone, the transmission range will be consid-
erably reduced!
̈
Only hold the radio microphone by its body.
It is vital to observe the notes on frequency
selection on page 25.
̈
Briefly press the ON / OFF button
¹
.
The radio microphone transmits an RF signal.
The red
ON LED
¾
lights up. The standard
display “ Frequency/Name ” appears on the
display panel. The transmission icon
ብ
is
displayed.
¶
¾
¹
P
ብ
ON/OFF