Sony Ericsson CDP-CX270 - Manual (Page 31)

Playing CDs in Various Modes
31
Additional Information Additional Information Additional Information
Specifications
Compact disc player
Laser Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 20 Hz to 20 kHz ± 0.3 dB
Dynamic range More than 98 dB
Harmonic distortion Less than 0.0027%
Outputs
LINE OUT
DIGITAL OUT
(OPTICAL)
MONITOR OUT
General
Power requirements 120 V AC, 60 Hz
Power consumption 19 W
Dimensions (approx.) When the front cover is closed
(w/h/d) 430 Ч 198.5 Ч 477 mm
(17
Ч
7 7/8
Ч
18 7/8 in.) incl. projecting
parts
When the front cover is open
430
Ч 198.5 Ч 600 mm
(17
Ч
7 7/8
Ч
23 5/8 in.) incl. projecting
parts
Mass (approx.) 9.6 kg (21 lbs 2 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Video cord (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
CD booklet holders (2)
Label (1)
Design and specifications are subject to change without notice.
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There is no sound.
/ Check that the player is connected securely.
/ Make sure you operate the amplifier correctly.
The CD does not play.
/ There is no CD in a slot (“–NO DISC–”
appears).
Insert a CD.
/ Insert the CD with the label side facing right.
/ Clean the CD (see page 30).
/ Moisture has condensed inside the player. Press
OPEN and leave the player turned on for about
an hour (see page 30).
The remote does not function.
/ Remove obstacles in the path of the remote and
the player.
/ Point the remote at the remote sensor g on the
player.
/ Replace all the batteries in the remote with new
ones if they are weak.
/ Set the CD 1/2/3 switch on the remote
according to the position of the COMMAND
MODE selector displayed in the front panel
display (see page 6).
The player functions incorrectly.
/ The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
reconnect it to the wall outlet to reset the player.
“Error” appears in the front panel display.
/ Consult your nearest Sony dealer.
Load impedance
Over 10 kilohms
Wave length: 660 nm
75 ohms, unbalanced,
sync negative
Maximum
output
level
2 V
(at 50 kilohms)
–18 dBm
1 Vp-p
Jack
type
Phono
jacks
Optical
output
connector
Phono
jack