Sony Ericsson CDP-CX270 - Manual (Page 6)

6
Getting Started
Controlling Another CD Player
(Player Control)
If you have a Sony CD player equipped with the
CONTROL A1 jack, you can control that player as the
second player with this unit. After connecting the
second player, you can select either player by simply
pressing the PLAYER SELECT button and enjoy
playing the discs inserted in both players. Be sure to
turn off the power of each player before making this
connection.
To CONTROL A1
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software
other than music, such as a CD-ROM.
When using another Sony CD player together with
this player
You can make the supplied remote effective only for this
player.
• When using a player equipped with the COMMAND
MODE selector:
Leave the COMMAND MODE selector of this player
to CD2 which is set at the factory and that of another
player to CD1 or CD3. Then set the CD1/2/3 switch on
the remote supplied for each player accordingly.
• When using a player not equipped with the
COMMAND MODE selector:
The command mode of the player without the
COMMAND MODE selector is set to CD1. Leave the
COMMAND MODE selector of this player and the
CD1/2/3 switch on the remote to CD2.
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Note on placement
Be sure to place the player on a horizontal surface.
If the player is slanted, it may cause a malfunction or
damage the player.
To an AC outlet
CDP-CX200 etc.
Amplifier
To an AC outlet
To audio input
To AC OUTLET
To audio output
: Signal flow
To CONTROL A1
To CONTROL A1
To LINE OUT To LINE IN
CDP-CX270/CX90ES
POC-15
Optical cable (not supplied)
CD player Digital component
DIGITAL OUT
OPTICAL
DIGITAL INPUT
OPTICAL