Speco Technologies CVC230HZ - Manual (Page 13)

Your camera provides three ‘WHITE BAL’ control modes for your choosing in
Adjusting the white balance.
1. Press the SET button to access the main setup menu and move the indicator to ‘WHITE BAL’
using the UP or DOWN button.
2. Set ‘WHITE BAL’ using the LEFT or RIGHT button.
MAIN SETUP
CAM TITLE
WHITE BAL
BACKLIGHT
MOTION DET
FOCUS
EXPOSURE
SPECIAL
RESET
EXIT
OFF
ATW
OFF
OFF
┘
┘
┘
┘
The three white balance control modes are as follows :
ATW (Auto Tracking White Balance) :
- OUTDOOR : This mode can be used within the color temperature
range 1,800~10,500K
(Ex: fluorescent light, outdoor, sodium vapor lamp or inside tunnels)
- INDOOR : This mode can be used within the color temperature range
3,000K~10,500K
AWC (Auto White balance Control) :
The white balance is automatically adjusted in a specific environment. In
order to obtain the best result, press the SET button while the camera
focuses
Manual :
To fine adjust, select the Manual mode. You can increase or decrease
the red or blue factor while monitoring the difference on the screen. Set to
‘MANUAL’ mode and press the SET button. Increase or decrease the
value for red (R-Gain) and blue (B-Gain), watching the color of the picture,
and press the SET button when you obtain the best color.