Sony DVP-NS705V EN - Manual (Page 28)

28
: Connecting to the 5.1ch input jacks
You can enjoy 5.1ch surround sound using
the internal Dolby Digital, MPEG audio, DTS
(DVP-NS905V only), or Super Audio CD
Multi decoder of this player. (When 6
speakers are connected, set “SURROUND”
to “OFF.”)
You can also enjoy Dolby Surround (Pro
Logic) sounds, or surround sounds using
various “SURROUND” modes (page 58).
: Connecting to a digital jack
This connection will allow you to use the
Dolby Digital, MPEG audio, or DTS decoder
function of your AV amplifier (receiver). You
are not able to enjoy the surround sound
effects of this player.
z Hints
• For connection
For correct speaker location, refer to the operating
instructions of the connected components.
• To enhance the sound performance:
– Use high-performance speakers.
– Use front, rear, and centre speakers of the same
size and performance.
– Place the subwoofer between the left and right
front speakers.
Notes
For connection
• After you have completed the connection, be sure
to set “DOLBY DIGITAL” to “DOLBY
DIGITAL” and “DTS” to “DTS”
(for DVP-NS905V) or “ON” (for DVP-NS705V)
in Quick Setup (page 29). If your AV amplifier
(receiver) has an MPEG audio decoder function,
set “MPEG” in “AUDIO SETUP” to “MPEG”
(page 80). Otherwise, no sound or a loud noise
will come from the speakers.
• When you connect an amplifier (receiver) that
conforms to the 96 kHz sampling frequency, set
“48kHz/96kHz PCM” in “AUDIO SETUP” to
“96kHz/24bit” (page 80).
• Super Audio CD audio signals are not output from
the digital jack.
D-1
D-2
D-2
D-2