Sony DVP-NS705V EN - Manual (Page 79)

79
Set
tings
a
nd
Adj
u
st
m
e
nt
s
◆ AUDIO FILTER (except Super Audio CD)
(DVP-NS905V only)
Selects the digital filter to reduce noise above
22.05 kHz (Sampling frequency (Fs) of the
audio source is 44.1 kHz), 24 kHz (Fs is 48
kHz), or 48 kHz (Fs is above 96 kHz).
Note
There may be little effect by changing the digital
filter depending on discs or playback environment.
◆ DOWNMIX (DVD VIDEO/DVD-RW only)
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital or DTS (DVP-NS905V
only) format. For details on the rear signal
components, see “Displaying the audio
information of the disc” (page 56).
This function affects the output from the
following jacks:
– LINE OUT L/R (AUDIO) jacks
– LINE (RGB)-TV jack (for DVP-NS705V)
– LINE 1 (RGB)-TV jack (for DVP-
NS905V)
– DIGITAL OUT (OPTICAL or COAXIAL)
jack when “DOLBY DIGITAL” and “DTS”
(DVP-NS905V only) are set to “D-PCM”
(page 79).
◆ DIGITAL OUT
Select this if audio signals are to be output via
the DIGITAL OUT (OPTICAL or
COAXIAL) jack.
Note
Super Audio CD audio signals are not output from
a digital jack.
Setting the digital output signal
Switches the method of outputting audio
signals when you connect a component such
as an amplifier (receiver) or MD deck with a
digital input jack.
For connection details, see page 22.
Select “DOLBY DIGITAL,” “MPEG,”
“DTS,” and “48kHz/96kHz PCM” after
setting “DIGITAL OUT” to “ON.”
If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, damaging your ears or speakers.
◆ DOLBY DIGITAL (DVD VIDEO/DVD-RW
only)
Selects the type of Dolby Digital signal.
STANDARD Normally select this position.
TV MODE Makes the low sounds clear
even if you turn the volume
down.
WIDE
RANGE Gives you the feeling of being
at a live performance.
SHARP Provides a wide frequency
range and spatial feeling.
SLOW Provides smooth and warm
sound.
DOLBY
SUR-
ROUND Select this when the player is
connected to an audio
component that conforms to
Dolby Surround (Pro Logic).
NORMAL Select this when the player is
connected to an audio
component that does not
conform to Dolby Surround (Pro
Logic).
ON Normally select this position. When
you select “ON,” see “Setting the
digital output signal” for further
settings.
OFF The influence of the digital circuit
upon the analog circuit is minimal.
D-PCM Select this when the player is
connected to an audio
component without a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
“DOWNMIX” item in
“AUDIO SETUP” (page 79).
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
OFF
STANDARD
AUDIO FILTER: SHARP
ON
DOWNMIX: DOLBY SURROUND
D-PCM
PCM
48kHz/96kHz PCM: 48kHz/16bit
DTS: D-PCM
, continued