Adjustments switching the input connector, Locking the controls – Sony GDM-17SE2T5 User Manual

Page 10

Advertising

Adjustments

Switching the Input Connector

As the monitor has two sets of input connectors, you can
switch between two input video signals. It is necessary to
select the connector type (HD15/5 BNC's) correctly
according to the connection.

Press the OPTION button.
The OPTION OSD (On Screen Display) appears.

Press the

buttons to select “INPUT” and then

press the

button to select “HD15” or “BNC.”

When you switch between input sources, the monitor screen
is muted for a moment (Mute) then the signal through the
selected input is displayed. If the selected input do not
receive any video signals, the monitor automatically returns
to the other input after Mute and the OPTION OSD appears.

To erase the OPTION OSD, press the OPTION button again.
The OSD automatically disappears 30 seconds after you
release the buttons.

If two computers are connected to the monitor (one to each
input), when one of the computers is turned on or restarted,
or the monitor goes into power saving mode, the monitor
may switch to the other input because the signal is
temporarily interrupted. Select the input which you use,
following the above steps.

Locking the Controls

This feature allows you to lock the monitor so that all the
buttons, except the

power switch and OPTION button, on

the front panel cannot be operated (Lock mode). Hence,
your settings cannot be modified. With this function, you
can ensure that your settings will remain the same even
when the control buttons are exposed to others.
To release the Lock mode, set it to off (UNLOCK) position.
Normally keep this function set to off (UNLOCK) position.

Press the OPTION button.
The OPTION OSD (On Screen Display) appears.

Press the

¨.

buttons to select “LOCK” and then

press the

buttons to select “LOCK.”

The

buttons do not work on the OPTION OSD.

The control buttons on the front panel except the OPTION
button do not work. If you press any button except the

power switch and OPTION button, the

mark

appears on the screen.

To Cancel the Control Lock

Press the OPTION button again.
Press the

buttons to select “UNLOCK.”

To erase the OPTION OSD, press the OPTION button again.
The OSD automatically disappears 30 seconds after you
release the buttons.

OPTION

COLOR TEMPERATURE
INPUT:
LOCK:

SET

SELECT

HD1 5

BNC

UNLOCK

LOCK

80.0KHz/ 75Hz