Sony GDM-17SE2T5 - Manual (Page 12)

12
This monitor complies with the DDC TM 1
,
DDC2B and
DDC2AB which are the Display Data Channel (DDC)
standards of VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V. CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification) to the data line.
When a DDC2B or DDC2AB host system is connected, the
monitor automatically switches to each communication.
DDC TM is a trademark of Video Electronics Standard
Association.
This monitor is capable of 3 states of reduced power
consumption.
By sensing the absence of one or both sync signals coming
from the host computer, it will reduce power consumption
as follows.
State
Normal
operation
Standby
(1st step
of power
saving)
Suspend
(2nd step
of power
saving)
Active-off
(3rd step
of power
saving)
Power-off
Power
consumption
≤ 140 W
≤ 100 W
≤
15 W
≤ 5 W
0 W
Required
resumption
time
—
approx.
3 sec.
approx.
3 sec.
approx.
10 sec.
—
u (power)
indicator
green on
green on
green on
off
off
POWER
SAVING
indicator
off
orange on
orange on
orange on
off
1
2
3
4
5
Power Saving Operation
The H-sync is not present.
The unit goes into standby state.
The V-sync is not present.
The unit goes into suspend state.
Both the H-sync and V-sync are not present.
The unit goes into active-off state.
The monitor requires a videocard or screen saver software
which switches off one or both sync signals to activate the
power saving function.
Caution: The Power Saving function will automatically put
the monitor into the Active-off state if the power
switch is turned on without any video signal
input. Once the horizontal and vertical syncs are
sensed, the monitor will automatically return to
its Normal operation state.
.
.
.
Mode
Plug and Play
Power Saving
Function
Use of the Tilt-Swivel
With the tilt-swivel, this unit can be adjusted to be viewed
at your desired angle within 90° horizontally and 20°
vertically.
To turn the unit vertically and horizontally, hold it at its
bottom with both hands as illustrated below.
Damper Wire
Using a white background, very thin horizontal stripes on
the screen are visible as shown below. These stripes are
damper wires. These wires are attached to the aperture
grille inside the Trinitron tube and are there to damp
vibrations of the aperture grille in order to prevent them
from influencing to the picture quality.
Damper wire
Approx. 6 cm
Approx. 6 cm