Configuring netbeui for printing – Savin SLP 38c SLP38C User Manual
Page 16
Windows 95/98/Me Configuration
10
2
B
Configure the TCP/IP protocol with the appropriate IP address, subnet
mask and other settings.
Confirm with the network administrator that the settings are correct.
Configuring NetBEUI for Printing
Follow these instructions to configure the printer and Windows 95/98/Me to
use the NetBEUI protocol.
❖
❖
❖
❖ Configuring the printer
Configure the printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default
is active.)
Reference
For more information about how to make the above settings, see “Config-
uring the printer for the Network” in Administrator Reference 1.
❖
❖
❖
❖ Configuring a Windows 95/98/Me computer
Install the NetBEUI protocol on the Windows 95/98/Me computer and set it
as the default protocol.
A
Open [Control Panel] and double-click the [Network] icon. Confirm that “Net-
BEUI” is listed in the [The following network components are installed:] box un-
der the [Configuration] tab.
Note
❒ If the NetBEUI protocol is not installed, click [Add] under the [Configura-
tion]
tab and install it. For more information about installing the Net-
BEUI protocol, see Windows 95/98/Me Help.
❒ If “NetBEUI ->Dial-Up Adaptor” is listed in the [The following network
components are installed:]
box, select it, and then click [Remove] to remove
the binding.
B
Set the NetBEUI protocol as the default protocol. Click the [Configuration]
tab, select “NetBEUI” in the [The following network components are installed:]
box, and then click [Properties].
C
Click the [Advanced] tab, select [Set this protocol to be the default protocol], and
then click [OK].
D
Click [OK] to close the [Network] dialog box.
E
When the message to restart appears, click [Yes].