Servis-Rhino CY84 - Manual (Page 136)

MAINTENANCE
CY84 03/08 Maintenance Section 5-2
© 2008 Alamo Group Inc.
MAINTENANCE
Before operating your Rotary Cutter, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and
trouble free operation.
Always disengage the PTO before raising the Rotary Cutter for transporting or making
adjustments.
Lubrication
Do not let excess grease collect on or around parts,
particularly when operating in sandy areas. The
illustrations below shows lubrication points. The
chart gives the frequency of lubrication in hours,
based on normal operating conditions. Severe or
unusual conditions may require more frequent
lubrication (Figure Mnt-0009).
Use an SAE multi-purpose, lithium-type grease for
all locations shown. Be sure to clean the fitting
thoroughly before using grease gun. Daily
lubrication of the wing driveline slip joint is
necessary. Failure to maintain proper lubrication will
result in damage to U-joints, gearbox, and/or
driveshaft.
Lubrication Fitting Location
ITEM DESCRIPTION FREQUENCY
1. U-Joints 8 hours
2. Gearbox Check Daily
3. Tail Wheel Pivot 10 hours
4. Wheel Hubs Weekly
5. Telescoping 8 hours