Speco Technologies 4HD - Manual (Page 20)

20
setting for every day.
[SUN to SAT]: Move the cursor to SUN to SAT and select a recording mode C,M or S using the SEL button
to set the same setting for the whole day.
[Vertical Bar
“ | “]: Move the cursor to ALL and move the cursor to the specific time using the control button
(
◀ ▲ ▶ ▼
). And select a recording mode C,M or S using the SEL button to set the same setting.
[SEL]: The recording mode can be selected by pressing repeatedly the SEL button.
[COPY FROM] [COPY TO]: Set the channel 1 schedule and select COPY TO using the control button (
◀
▲ ▶ ▼ ), select CH2 using the control button ( ◀ ▲ ▶ ▼ ) and press the SEL button. Then the CH1
schedule is copied to CH2.
To return to setup menu screen, press the ESC button.
3-4. Setup
– Device Mode
Press the SETUP button and enter the password. The setup menu is displayed as picture below. Select
DEVICE icon and press SEL button to enter the setup menu item. Navigate through the menu items using
the control button (
◀ ▲ ▶ ▼
) and change the value of the menu item using the control button (
◀ ▲ ▶
▼
).To return to setup menu screen, press the ESC button.
Figure 3.4.1. Device Mode Setup Screen
Table 3.4.1. Menu Items in Device Setup Screen
Item Description
ALARM OUT Set the sensor, motion, and video loss for each alarm.
PTZ Set the PTZ camera speed, number, type and ID.
CHANNEL Select specified channel for motion zone setup.
MOTION ZONE Select either Full Zone or Partial Zone for motion sensing.
MOTION SENSITIVITY Set the motion sensitivity for the specified channel.