SIGMA EQ Station - Manual (Page 28)

26
CONTROL SECTION
Basic Operation in the Control Section
• Press RECALL, STORE, SETUP or UTILITY to access these pages.
• Navigate using the ARROW keys.
• Use the ADJUST wheel to change parameter values.
Settings are instantly active.
Setting up Names, Device Number and Subnet Masks etc:
• Select the parameter using the ARROW keys and press OK.
• A display similar to the illustration below then pops up.
• Use the Left/Right ARROW keys to set cursor position
• Use the ADJUST wheel to select letter or number
• Use the Up/Down ARROW keys to select function:
Capital or lower-case letters; numbers or Cancel if you wish to abort the entire operation.
• Press OK to confirm and exit the display.
SELECT ARROW keys
ADJUST wheel for
parameter adjustment
OK key
For entering and
confirmation