SUPER MICRO Computer AOC-USAS-L4i - Manual (Page 19)

3-3
Safety Information and Technical Specifications
Note: When you start the MegaRAID BIOS CU by pressing Ctrl-H the Configuration
Manager Module of the BIOS allocates three segments of memory using either PMM
or conventional memory: these are the Destination Segment, Scratch Segment, and
Read Write Buffer Segment. If the three segments are not available the BIOS hooks
INT19h and loads the CU at the fixed segments 5000:0 (Destination Segment),
6000:0 (Scratch Segment) and 7000:0 (Read Write Buffer Segment) after POST.
Using Easy Configuration
When you select the Easy Configuration option, the CU creates one or more arrays
from the available physical drives and configures each array as a single logical drive.
If logical drives have already been configured, the CU does not change their con-
figuration. Follow these steps to create a logical drive using Easy Configuration:
1. Select Configuration→ Easy Configuration from the Management Menu. A list of
available (READY) physical drives appears.
2. Use the arrow keys to select the physical drives to include in the array.
3. Press the spacebar to add each selected physical drive to the new array.
When you select a physical drive, its status changes from READY to ONLIN
A[array number]-[drive number]. For example, ONLIN A00-01 means array 0,
disk drive 1.
4. To create a global hotspare drive, highlight a READY disk drive and press F4.
Then select Yes from the pop-up menu.
5. To define multiple arrays, select all the drives you want for the first array, then
press Enter to start selecting drives for the second array, and so on.
6. When you have selected drives for all desired arrays, press F10.
7. Press the spacebar to select an array.
The Logical Drive Configuration screen appears, as shown in Figure 3-2. This
screen shows the logical drive number, RAID level, logical drive size, number of
stripes in the physical array, stripe size, and state of the logical drive.