Sanyo VCC-WB2000 - Manual (Page 19)

Network Camera Settings
A NETWORK SET Settings
These settings are used in order to connect the camera to the network.
Note: Check with the network system administrator for details on settings related to the network itself,
such as IP address settings.
1
Click the [NETWORK] button in the main
menu.
The initial NETWORK SET window will be
displayed. The default settings for each item
will be displayed automatically. Check with
the network system administrator or Internet
Service Provider if you need to change any
of the following settings.
•
IP ADDRESS
•
SUBNET MASK
•
GATEWAY
2
Set the password.
There are three access levels available
(User, Operator and Administrator) and
separate passwords can be set for each
level. The range of operations varies for
each level as shown in the table below.
Username ID1 ID2 ID3
Access level
User Operator
Adminis-
trator
Password
(default)
1111 2222 3333
Live image
viewing
F F F
Menu
settings
T F F
Main menu
button
operation
T v F
v : Camera settings only
Note: The passwords are set as shown in the
table above at the time of shipment from
the factory. However, it is recommended
that you change them whenever possible
for security purposes.
3
Once you have finished changing the
settings, click the [SET] button.
2
3
4
Reset if necessary
Default settings displayed
1
L5AB2/US (VCC-WB2000) GB 2002, 7, 4
– 18 – English