Sanyo VCC-WB2000 - Manual (Page 36)

Alarm Setting
The camera is equipped with two types of alarm function: an external alarm sensor and a motion
sensor. When an outside intruder is detected, these alarm functions can be used to record the images
immediately before the alarm occurred (pre-alarm recording) and the alarm images themselves
(post-alarm recording) into the camera’s internal memory or onto a memory card.
When an alarm is received, the ALARM indicator illuminates red on the live image screen, so that you
can check if an alarm is being received or not.
External Alarm Sensor Settings
1
Make the following connections.
When using this unit, the supplied clamping
core A must be installed on the power cord,
in order to prevent electromagnetic
interference to the other devices connected.
1 Connect an infrared sensor or similar to
the ALARM IN terminal at the rear of the
camera.
2 Connect a buzzer or lamp to the ALARM
OUT terminal.
2
Click the [ALARM] button in the main
menu.
The ALARM SET screen will be displayed.
3
Change the EXTERNAL ALARM setting to
“ NC” or “ NO” .
You can then select the items that are
required for setting external alarms.
Note: Set MOTION DETECTOR to “OFF”.
1
2
3
4
5
6
7
8
9
F
PC CARD
RS-232C
ALARM IN OUT
MODEM
PC
COM AC24V
DC12V
GND
1 2
ETHERNET
POWER
MONITOR
OUT
Infrared sensor or similar
Buzzer or lamp
A
CLASS 2 WIRING
ID3
L5AB2/US (VCC-WB2000) GB 2002, 7, 4
English – 35 –